Lexmark C530 - Page 23

4 Attach the ribbon cable to the hard disk.
5 Align the screw holes on the mounting plate with the holes in the hard disk.
6 Secure the mounting plate to the hard disk with the screws.
7 Press the ribbon cable connector into the connector on the system board.
8 Flip the hard disk over, and then press the three posts on the mounting plate into the holes on the system board.
The hard disk snaps into place.
2
1
9 Reinstall the system board access cover. For more information, see “Reinstalling the system board access cover”
on page 25.
Installing options
23