Installing internal options
CAUTION: If you are installing memory or option cards sometime after setting up the printer, turn the printer off
and unplug the power cord before continuing. If you have any other devices attached to the printer, turn them
off as well and unplug any cables going to the printer.
You can customize your printer connectivity and memory capacity by adding optional cards. The instructions in this
section explain how to install the available cards; you can also use them to locate a card for removal.
Available options
Memory cards
• Printer memory
• Flash memory
• Fonts
Firmware cards
• Bar Code
• PrintCryption™
Note: Use a #2 Phillips screwdriver to remove the system board access cover.
Other internal options
The following internal options may be installed on some models:
• Printer hard disk
• RS-232 serial interface card
• Parallel 1284-B interface card
• MarkNet
TM
N8000 Series internal print servers
Accessing the system board to install internal options
Remove the system board cover to access the system board.
Note: This operation requires a #2 Phillips screwdriver.
CAUTION: Turn the printer off, and unplug the power cord before continuing.
Installing options
15