3 Release both buttons when Performing Self Test appears.
The printer performs its power-on sequence, and then CONFIG MENU appears.
4 Press until Panel Menus appears, and then press .
5 Press until Enable appears, and then press .
Submitting Selection, Enabling Menus, and Panel Menus appear briefly.
6 Press until Exit Config Menu appears, and then press .
When Activating Menu Changes appears, the menus are enabled. Resetting the Printer appears
briefly, followed by a clock, and then Ready appears.
Disabling Quick Start mode
Quick Start mode allows the printer to begin printing before the engine has warmed to normal operating temperature.
When the printer receives a print job, the pages print slowly at first, and then more quickly as the printer warms up.
This reduces the overall time required to print a job from a standby mode.
Quick Start mode is turned on by default.
To turn Quick start mode off:
1 From the control panel, press .
2 Press until Settings appears, and then press .
3 Press until Setup Menu appears, and then press .
4 Press until Quick Start appears, and then press .
5 Press until Off appears, and then press .
Submitting Selection appears, followed by Ready.
Restoring factory default settings
Menu settings marked with an asterisk (*) indicate the active settings. You can restore the original printer settings,
often referred to as the factory default settings.
1 Make sure the printer is on and Ready appears.
2 From the control panel, press .
3 Press until Settings appears, and then press .
4 Press until Setup Menu appears, and then press .
5 Press until Factory Defaults appears, and then press .
6 Press until Restore Now appears, and then press .
Restoring Factory Defaults appears briefly, then Ready appears.
Administrative support
76
To Next Page
Loading...
