Notes:
• The entire length of the connector on the card must touch and be flush against the system board.
• Be careful not to damage the connectors.
5 Reinstall the system board access cover.
6 Set the printer software to recognize the flash memory.
a Click Start Settings Printers.
b Double-click the printer icon.
c Click File Properties.
d Click the Install Options tab.
e From the Available Options list, select Flash memory.
f Click Add.
g Click OK.
Installing a printer hard disk
Note: A #2 Phillips screwdriver is needed to attach the hard disk to the mounting plate.
Warning: Hard disks are easily damaged by static electricity. Touch something metal on the printer before touching
a disk.
Note: If an option card has been installed, you may need to remove it before installing the hard disk.
1 Access the system board. For more information, see “Accessing the system board to install internal options” on
page 15.
2 Remove the mounting plate, hard disk, ribbon cable, and attachment screws from the package.
3 Align the ribbon cable connector with the connector pins on the hard disk.
Installing options
22
To Next Page
Loading...
