Some held jobs were not restored
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
• Turn off the printer and then turn it back on.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at
http://support.lexmark.com.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models, press
to confirm.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
Supply needed to complete job
Try one or more of the following:
• From the printer control panel, touch Prompt for supplies to view all error messages that indicate what supplies
are needed to continue processing the current job. For non‑touch‑screen printer models, press
to clear the
message and continue printing.
1 Order the missing supply immediately.
2 Install the supply. For more information, see the instruction sheet that came with the supply.
• Cancel the print job, then install the missing supply, and then resend the print job.
Too many flash options installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra flash memory.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Troubleshooting 154
To Next Page
Loading...
Need help?
General
