Lexmark CS410 series User Manual

Use To
On Reduce printer noise.
Notes:
• Print jobs process at a reduced speed.
• Printer engine motors do not start until a document
is ready to print. There is a short delay before the
first page is printed.
• The alarm control and cartridge alarm sounds are
turned off.
• The printer will ignore the Advance Start command.
Off Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
2 Press .
Adjusting Sleep mode
1 From the control panel, navigate to:
> Settings > > Settings > > General Settings > > Timeouts > > Sleep Mode >
2 In the Sleep Mode field, select the number of minutes the printer is idle before it enters Sleep mode.
3 Apply the changes.
Using Hibernate mode
Hibernate is an ultra‑low‑power saving mode.
Notes:
• Three days is the default amount of time before the printer enters Hibernate mode.
• Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long press of
the Sleep button wakes the printer from Hibernate mode.
• If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1 From the control panel, navigate to:
> Settings > > Settings > > General Settings >
2 Select Press Sleep Button or Press and Hold Sleep Button, and then press .
3 Press Hibernate > .
Saving money and the environment 99

Lexmark CS410 series Specifications

General

Print Technology	Color Laser
Print Speed (Letter, Black)	32 ppm
Print Speed (Letter, Color)	32 ppm
Print Resolution (Black)	1200 x 1200 dpi
Print Resolution (Color)	1200 x 1200 dpi
Processor Speed	800 MHz
First Page Out Time (Black)	9 seconds
Maximum Paper Size	8.5 x 14 inches
Supported Operating Systems	Windows, Mac OS, Linux
Monthly Duty Cycle	75, 000 pages
Input Capacity	250 sheets
Output Capacity	150 pages
Connectivity	USB, Ethernet
First Page Out Time (Color)	9.5 seconds
Recommended Monthly Page Volume	750 to 3, 000 pages