Lexmark CS410 series User Manual

Action Yes No
Step 3
Check if you are using a recommended type of paper.
a Load paper source with a recommended type of paper.
b Resend the print job.
Do vertical voids appear on prints?
Go to step 4. The problem is solved.
Step 4
a Remove, and then reinstall the imaging kit.
Warning—Potential Damage: Do not expose the imaging kit to
direct light for more than 10 minutes. Extended exposure to light
may cause print quality problems.
Warning—Potential Damage: Do not touch the underside of the
imaging kit. This could damage the imaging kit.
b Resend the print job.
Do vertical voids appear on prints?
Go to step 5. The problem is solved.
Step 5
Replace the imaging kit, and then resend the print job.
Do vertical voids appear on prints?
Contact
customer
support.
The problem is solved.
Uneven print density
Action Yes No
Replace the imaging kit, and then resend the print job.
Is the print density uneven?
Contact
customer
support.
The problem is solved.
Troubleshooting 185

Lexmark CS410 series Specifications

General

Print Technology	Color Laser
Print Speed (Letter, Black)	32 ppm
Print Speed (Letter, Color)	32 ppm
Print Resolution (Black)	1200 x 1200 dpi
Print Resolution (Color)	1200 x 1200 dpi
Processor Speed	800 MHz
First Page Out Time (Black)	9 seconds
Maximum Paper Size	8.5 x 14 inches
Supported Operating Systems	Windows, Mac OS, Linux
Monthly Duty Cycle	75, 000 pages
Input Capacity	250 sheets
Output Capacity	150 pages
Connectivity	USB, Ethernet
First Page Out Time (Color)	9.5 seconds
Recommended Monthly Page Volume	750 to 3, 000 pages