Lexmark CS510 - Networking; Preparing to Set up the Printer on an Ethernet Network

2
3
6
4
5
1
Use the To
1 Rear USB port Attach a keyboard to the printer.
2 USB printer port Connect the printer to a computer.
3 Ethernet port Connect the printer to a network.
4 USB wireless port Attach an optional wireless network adapter.
5 Security lock port Lock the system controller board.
6 Printer power cord socket Connect the printer to a properly grounded electrical outlet.
Networking
Notes:
• Purchase a MarkNet
TM
N8352 wireless network adapter first before setting up the printer on a wireless network.
For information on installing the wireless network adapter, see the instruction sheet that came with the
adapter.
• A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP), Wi-Fi
Protected Access (WPA), WPA2, and 802.1X - RADIUS are types of security used on a network.
Preparing to set up the printer on an Ethernet network
To configure your printer to connect to an Ethernet network, organize the following information before you begin:
Note: If your network automatically assigns IP addresses to computers and printers, continue on to installing the
printer.
• A valid, unique IP address for the printer to use on the network
• The network gateway
Additional printer setup 41