Installing a printer hard disk
Note: This task requires a flathead screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static electricity.
Touch something metal on the printer before touching any controller board electrical components or connectors.
1 Access the controller board.
For more information, see “Accessing the controller board” on page 26.
2 Unpack the printer hard disk.
3 Remove the screws attached to the printer hard disk mounting bracket, and then remove the bracket.
Additional printer setup 32
To Next Page
Loading...
