Lexmark Optra W810 - Page 227

Troubleshooting
227
You cannot print using
the infrared port on the
tri-port interface card.
The infrared port is not
configured properly.
Make sure neither Infrared Port nor
Infrared Buffer is set to Disabled in
the Infrared Menu. Also make sure
the Window Size and Transmit Delay
settings are correct.
The connection between the
two infrared devices cannot be
made.
Make sure the distance between the
two infrared ports is 3 m (10 ft) or
less. If necessary, move the ports
closer together.
Refer to the
Setup Guide for more
information.
Make sure no objects are between
the two ports.
Make sure the computer is set on a
level surface.
If necessary, turn off the lights in the
room or close window shades or
blinds. Bright light, such as direct
sunshine or nearby artificial lights,
may interfere with communication.
You cannot print using
the LocalTalk port.
The LocalTalk port is not set up
correctly.
Make sure neither LocalTalk Port nor
LocalTalk Buffer is set to Disabled in
the LocalTalk Menu.
Note:
For Macintosh users, verify
that the printer is set up correctly in
the Macintosh Chooser.
Other printing problems (continued)
Symptom Cause Solution