41Mainframe Installation Setup: Task 3 -Configuring a Print Server
Task 3 -
Configuring a
Print Server
SCS/TNe Emulation printing requires a MarkNet internal print server
or a Standard Network port on the printer.
A. To check the installed print server firmware version
IMPORTANT:
The SCS/TNe Emulation can only receive jobs
through a single printer server. Moving the
selected print server or inserting a new print
server may cause a loss of SCS/TNe print
capability.
1 From a Ready state touch Menus.
2 Touch Reports.
3 Scroll until one or more of the following appears. If none of
these appear, then you do not have a Standard Network or
internal print server installed.
a If Network Setup Page appears, touch it. This prints the
Standard Network Card menu settings page.
b If Network # Setup Page appears, touch it. This prints a
settings page for the internal print server in slot #, where # is a
number representing the slot in which the print server is
installed.
To Next Page
Loading...
