80Operations - Common Setup: Disconnect Ses
Disconnect Ses This option disconnects all active TNe sessions on TCP/IP level.
The SCS/TNe Emulation will attempt to reconnect when the printer
is powered Off and On or when a Reset TN Ses. is performed. See
the Reset TN Session option below.
A Disconnect Ses. should be performed before powering Off the
printer.
Operator panel text Comments
Do Not Disconn. Do not disconnect any sessions. This performs the
same action as if Back had been pressed in the
operator panel.
Disconnect Ses. Disconnect ALL active TNe sessions. The printer
must be powered Off and On or a Reset TN Ses.
must be performed before the SCS/TNe Emulation
will attempt to contact the host.
To Next Page
Loading...
