66AS/400 and iSeries Installation Setup: Task 4 - Configuring the SCS/TNe Emulation
Task 4 -
Configuring the
SCS/TNe
Emulation
SCS jobs are printed from a LAN connected AS/400 or iSeries host
using TCP/IP and the telnet extended (TN5250e) protocol. Up to
four TN5250e print sessions can be established with a single or
multiple hosts.
To configure the SCS/TNe Emulation
IMPORTANT:
Powering the printer Off and On does not end
TCP/IP and Telnet sessions in an orderly manner.
To power the printer Off properly, select Menus >
Option Card Menu > SCS/TNe MENU >
COMMON SETUP > Disconnect Ses >
Disconnect Ses.
See: Disconnect Ses, page 80.
1 Select Menus > Option Card Menu > SCS/TNe MENU >
TN5250E SETUP.
2 Select CONNECTION #1, CONNECTION #2,
CONNECTION #3, or CONNECTION #4
3 Select SERVER # INFO.
4 Configure the SERVER # INFO options.
5 Locate and touch each option. Enter or scroll to new values
and touch Submit to save your settings. The menu will return
to the SERVER # INFO menu group within which you scroll
to the next desired option. When you are finished with all
options within SERVER # INFO, touch Home to exit.
To Next Page
Loading...
