43Mainframe Installation Setup: Task 3 -Configuring a Print Server
2 Set the Job Timeout. This timeout is used by all print
servers. Select Menus > Network/Ports. Select the print
server to be used for SCS printing, for example Standard
Network. Select Standard Network > Std Network Setup >
Network Card > Job Timeout. Scroll down to 0. Touch
Submit to save.
3 Set the TCP/IP option values shown in the table below.
Select Menus > Network/Ports > Standard Network > Std
Network Setup > TCP/IP. You will need to contact your
network administrator for several of the values.
Option Value Description
Network Job
Timeout
0 This is the recommended setting and corre-
sponds to “disabled”. Other settings may cause
communication problems. A setting of "0" allows
the host or SNA server timeout values to control
when print jobs from another protocol, interface,
server, or host can be started.
To Next Page
Loading...
