DO THE PRINT CARTRIDGES HAVE INK?
1 Click Programs or All Programs Lexmark X5400 Series.
2 Click Solution Center.
If an exclamation point (!) appears on either of the print cartridges, the ink level is low. Install a new cartridge.
For more information, see the related topic below.
IS THERE A PROBLEM WITH THE CONNECTIONS?
For more information, see the related topic below.
Settings are not saved
These are possible solutions. Try one or more of the following:
CHANGE TIME-OUT SETTINGS
If you press to select a setting, an * appears next to the selected setting. The printer reverts to the default setting
after two minutes of inactivity or if the printer is turned off.
SAVE SETTINGS
If you press to select a setting, an * appears next to the selected setting.
Checking the Spool Settings for banner printing
Banner printing is not possible if certain Spool Settings are selected. Verify that you have the right settings selected.
1 Click Start Settings Printers or Printers and Faxes.
2 Right-click the Lexmark X5400 Series icon.
3 Select Properties.
4 Click the Advanced tab.
5 At the bottom of the Advanced tab, click Print Processor.
6 Verify that the Default data type is LEMF. If it is not, select LEMF from the available choices, and then click OK.
Resolving font problems
H
AVE YOU APPLIED THE FONTS CORRECTLY IN THE PROGRAM?
Most programs do not print a stretched or resized font.
IS THE FONT A TRUETYPE FONT? IS IT AVAILABLE ON THE COMPUTER?
The font you are trying to print may not be available in the program font selection box. Not all fonts are designed
to be printed; make sure the font is a TrueType font. See the program documentation for more information.
Troubleshooting
102
To Next Page
Loading...
