INITIALIZATION OF FRONT MEMORY SEAT ECU DURING PDS -- PD075-06 September 27, 2006
Page 2 of 3
2. Operate the seat position control switch and slide the seat to the rearmost position.
NOTE:
When operating the control switch, the warning buzzer sounds.
After operating the seat position
control switch, the following
operations will occur automatically:
S The head restraint automatically
moves to the uppermost position
and a beep is heard.
S The seat cushion length
automatically slides to the
rearmost position and a beep
is heard.
HINT:
The two seat operations described
above occur simultaneously.
3. Move the seatback angle switch
forward until a beep is heard.
Driver’s Seat
Initialization
Procedure
(Continued)
To Next Page
Loading...
