2Important safety information
2.1Mechanical hazards
WARNING: VACUUM HAZARD
Risk of physical injury. Do not expose any part of the human body to vacuum as it
can cause injury.
WARNING: HEAVY OBJECT
Risk of physical injury. Use suitable lifting equipment.
CAUTION: ROTATING PARTS
Risk of physical injury. Care must be taken not to touch any rotating parts.
CAUTION: AUTO-RUN MODE
Risk of physical injury. The system has an Auto-run mode which is designed to
automatically start the pump system once power is applied.
▪ Do not operate the pump if the exhaust pipeline is restricted or blocked▪
as the pump will not operate correctly and may be damaged.
▪ If operating in Auto-run mode, make sure that no unsafe situation can▪
be created and inform the users of this mode. Make sure that mains is
disconnected before opening any part of the vacuum chamber.
▪ Make sure that any cabling and/or pipe work attached to the pump are▪
routed carefully to avoid causing a slip/trip hazard and to prevent any
damage to the cable.
▪ Install the pump in the vacuum system before you connect the power▪
supply. This will make sure that the pump can not operate and injure
people during installation.
▪ Local legislation concerning the impact of the pump on the environment▪
must be followed when installing and removing the pump.
▪ Do not operate the pump with an open inlet as this may cause damage▪
to the pump and/or injury to people.
2.2Electrical hazards
WARNING: HAZARDOUS VOLTAGE
Risk of electric shock. Do not operate the pump with any parts of the enclosures
removed or damaged as there may be a risk of an electric shock.
The electrical installation must be performed by a qualied person. Always make
the electrical connections after the pump has been installed on the vacuum
system.
10 300668736_002_C7 - © Leybold
Important safety information