This product has been manufactured under a quality management system certified to ISO 9001:2015
EU Declaration of Conformity
This declaration of conformity is issued under the sole responsibility of the manufacturer:
Leybold GmbH
Bonner Strasse 498
D-50968 Köln
Germany
Documentation Officer
T: +49(0) 221 347 0
documentation@leybold.com
The product specified and listed below
Type designation:
SCROLLVAC 7 plus
SCROLLVAC 10 plus
SCROLLVAC 15 plus
SCROLLVAC 18 plus
Standard
141007Vx0
141010Vx0
141015Vx0
141018Vx0
Part numbers:
H-Version
141007Vx1
141010Vx1
141015Vx1
141018Vx1
C-Version
141007Vx2
141010Vx2
141015Vx2
141018Vx2
Where 1-ph x=1, 3-ph x=3
Is in conformity with the relevant Union harmonisation legislation:
Machinery directive
Note: The safety objectives of the Low Voltage Directive 2014/35/EU were complied with in accordance
with Annex 1 No. 1.5.1 of this directive.
ATEX directive on use in potentially explosive atmospheres
II 3 G Ex h IIC T4 Gc X
Only the internal pumping mechanism is classified as ATEX category 3, external parts and motor are
not in scope
Electromagnetic compatibility (EMC) directive
Class A Emissions, Industrial Immunity
Batteries directive - Applicable to 3-ph variants only
Restriction of certain hazardous substances (RoHS) directive as amended by Delegated Directive (EU)
2015/863
Based on the
relevant requirements of harmonised standards:
Compressors and vacuum pumps. Safety requirements. Vacuum pumps
Safety requirements for electrical equipment for measurement, control and laboratory
use. General requirements
Explosive atmospheres – Part 36: Non-electrical equipment for explosive atmospheres.
Basic method and requirements
Explosive atmospheres – Part 37: Non-electrical equipment for explosive atmospheres –
Non-electrical type of protection constructional safety <c=, control of ignition sources <b=,
liquid immersion <k=
Electrical equipment for measurement, control and laboratory use. EMC requirements.
General requirements
To Next Page
Loading...
