LEYBOLD SCROLLVAC plus - Page 72

This product has been manufactured under a quality management system certified to ISO 9001:2015
P20010429B
Declaration of Conformity
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Leybold GmbH
Bonner Strasse 498
D-50968 Köln
Germany
Documentation Officer
Innovation Drive
Burgess Hill
West Sussex
RH15 9TW
documentation@leybold.com
The product specified and listed below
Type designation:
SCROLLVAC 7 plus
SCROLLVAC 10 plus
SCROLLVAC 15 plus
SCROLLVAC 18 plus
Standard
141007Vx0
141010Vx0
141015Vx0
141018Vx0
Part numbers:
H-Version
141007Vx1
141010Vx1
141015Vx1
141018Vx1
C-Version
141007Vx2
141010Vx2
141015Vx2
141018Vx2
Where 1-ph x=1, 3-ph x=3
The object of the declaration described above is in conformity with relevant statutory requirements:
Supply of Machinery (Safety) Regulations 2008
The objectives of the Electrical Equipment (Safety) Regulations 2016 are governed by Annex 1 1.5.1 of this regulation.
Equipment and Protective Systems Intended for use in Potentially Explosive Atmospheres Regulations 2016
II 3 G Ex h IIC T4 Gc X
Only the internal pumping mechanism is classified as ATEX category 3, external parts and motor are not in scope
Electromagnetic Compatibility Regulations 2016
Class A Emissions, Industrial Immunity
Batteries and Accumulators (Placing on the Market) Regulations 2008 - Applicable to 3-ph variants only
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012
Relevant designated standards or technical specifications are as follows:
EN 1012-2:1996 +A1:2009
Compressors and vacuum pumps. Safety requirements. Vacuum pumps
EN 61010-1:2010 +A1:2019
Safety requirements for electrical equipment for measurement, control and laboratory
use. General requirements
EN ISO 80079-36:2016
Explosive atmospheres – Part 36: Non-electrical equipment for explosive atmospheres.
Basic method and requirements
EN ISO 80079-37:2016
Explosive atmospheres – Part 37: Non-electrical equipment for explosive atmospheres –
Non-electrical type of protection constructional safety <c=, control of ignition sources <b=,
liquid immersion <k=
EN 61326-1:2013
Electrical equipment for measurement, control and laboratory use. EMC requirements.
General requirements