Removing (Panel) Flexible Ribbon Cables from Y-Drive Upper or Lower
Flexible Ribbon Cables shown may be different, but process is the same.
To remove the Ribbon Cable from the connector first carefully lift the Locking Tab from
the back and tilt it forward ( lift from under the tab as shown in Fig 1).
The locking tab must be standing straight up as shown in Fig 2.
Lift up the entire Ribbon Cable gently to release the Tabs on each end. (See Fig 3)
Gently slide the Ribbon Cable free from the connector
.
Gently Pry
Up Here
Be sure ribbon tab is released
By lifting the ribbon up slightly,
before removing ribbon.
Locking tab in
upright position
Fig 1
Fig 3
Fig 2
June 2011 42PW350 Plasma
10 4
To reinstall the Ribbon Cable, carefully slide it back into the slot see ( Fig 3 ), be sure the Tab is seated
securely and press the Locking Tab back to the locked position see ( Fig 2 then Fig 1).
To Next Page
Loading...
