27
June 2011 42PW350 Plasma
42PW350 Model Number Download Screen
1. Adjust Check
2. ADC Data
3. Power Off Status
4. System 1
5. System 2
6. Model Number D/L
7. Test Option
8. External ADC
9. Pattern Selection
10. Panel Control
11. Spread Spectrum
12. Sync Level
13. Stable Count
14. ODC Test
15. Power Error History
0. Model Name
1. Serial Num.
Model Number D/L
Press OK to Save
42PW350-UA
Bring up the Service Menu using the Service Remote
by pressing “In-Start” enter password 0413 or 0000.
Scroll down to item 6. Model Number D/L to highlight.
Press “ENTER” or “Cursor Right”.
IN START
010PTZK1F285
Model Name: 42PW350-UA
Serial Number: 010PTZK1F285
S/W Version:
MICOM Version
SPI Boot Version
BOOT Version
Touch Version
EDID Version (RGB)
EDID Version (HDMI)
Chip Type
3D ASIC Version
Debug Status
Module Rom Ver:
RF Emitter Versioni
UTT : 12
APP History Ver.:53810
PQL DB:LGE_PG_LGT10_xxN42
: 03.26.02.11
: 3.24.0
: 4.24.00
: 0.01.17
: 0.05 (0x00)
: 0.01
: 0.01
: SATURN 7
: 0.77
: RELEASE
: 42T3_4PV3A0
: VB091
To Change the Model Number:
1) Use the cursor right or left to select the area
to change.
2) Use the cursor up or down to change.
3) When Model Number is correct,
Press “ENTER” to Save
4) Cursor right until there is no text cursor blinking.
5) Cursor down to highlight “Serial Number”
6) Cursor Right to place blinking cursor under the first
location and change (as in Item 2 above).
5) Press “ENTER” to Save
Note: To return to the Model Number, Cursor right
until there is no text cursor blinking and press the Up
Cursor on the Remote. Cursor Right to place blinking
cursor under the first location
When the Main Board is replaced, the Model Number and
Serial Number must be corrected. Follow these instructions
Select
Item 6
Note: The Model and/or Serial No. will not
change until you press the “In-Start” button
after any change has been made.
To Next Page
Loading...
