To Next Page

To Previous Page

3-3

COMPONENT ACCESS

REMOVING THE CONTROL POWER SUPPL

AND POWER CONTROL BOARD (PCB)

1. Turn off the electrical supply going to the range.

2. Pull the range away from the wall so that you can

access the rear panel.

3. Remove back cover & control cover (See step

3~4 on page 3-2)

4. There are 3 PCB's (power control board). When

you check PCB, check the proper pcb in default

mode and check main pcb.

NOTE: Refer to the page 5-1~5-3 for

composition of control board

5. To remove the control power supply:

a) Disconnect 2 connectors.

b) Remove the two screws.

WARNING

ELECTRICAL SHOCK HAZARD

Disconnect power before servicing the range.

Replace all panels before operating range.

Failure to do so can result in death or electrical

shock.

CAUTION

When you work on the electric range, be careful

when handling the sheet metal parts. Sharp

edges may be present, and you can cut yourself if

you are not careful.

Oven

Relay PCB

Main PCB

2 Connector

2 Screws

LG LRE30451ST Service Manual

Other manuals for LG LRE30451ST