3-17
COMPONENT ACCESS
REMOVING A SIDE P
REMOVING A SIDE P
ANEL
ANEL
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electrical
shock.
!
CAUTION
When you work on the electric range, be careful
when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
7. Remove the two screws from the left or right side
panel.
8. Pull the back of the side panel out from the range
approximately 10
˚
.
9. Push forward and remove the side panel.
1. Turn off the electrical supply going to the range.
2. Remove the oven door from the range
(see page 3-13 for the procedure).
3. Pull the range away from the wall so you can
access the back of the unit.
4. Remove the 16 screws from the rear panel and
remove the panel (see step 3~4 on page 3-2).
5. Raise the cooktop (see page 3-4 for the
procedure). NOTE: Position the side of the
cooktop so that it does not rest on the side panel
that you are removing.
6. Remove the two screws from the top rear of the
side panel.
To Next Page
Loading...
Need help?
General
