7-2
F-CODE FLOW CHART
Door lock system error
F-2 error
Code Error mode Operation Times/sampling
F-2 Door Lock Fail In case of Door Lock Failure
→ Just after self-clean start, the door lock motor starts to rotate. During that time if the door lock switch
does not operate properly after rotating twice, then supervising circuit detects a Door Lock failure and
the F-2 error code appears
.
Reconnect
Normal?
END
No
Yes
Door lock failed
Disconnect power
Check for loose connection on the micro switch
and the door locking motor.
Check the oven door lock switch(micro switch)
(measure the resistance
→
Normally open type)
NO
COM
Door latch
open
Door latch
Locked
Continuity Infinite
Continued on the next page
To Next Page
Loading...
Need help?
General
