LI-COR LI-600 - Taking a Measurement in Auto Mode

Section 3. Taking Measurements
3-5
"no" and the LI-600 will perform a serial, valveless
match.
Do not enter match mode with a leaf in the chamber.
Matching with a leaf in the chamber will ruin sub-
sequent measurements.
Taking a measurement in Auto Mode
In Auto Mode, the LI-600 automatically logs a meas-
urement when the stability criteria set in the con-
figuration are met.
To take a measurement in Auto Mode:
1
Power on the LI-600.
2
Select a configuration with Auto mode enabled and
press Enter. The instrument will match the RHsensors and go
to the Measurement screen. If Prompt on log is not
enabled and you want to add data labels or scan a barcode,
press the right arrow (Prompt) to Data labels (Press enter
to edit highlighted values). Select a data label, press
the Enter button, and choose from the options. If you've
enabled the barcode scanner with a data label, follow the
steps below for using the barcode scanner. Select Done and
press Enter to go back to the Measurement screen.
3
At the prompt Clamp on leaf, open the aperture with the
aperture clamp and close it onto the leaf. The instrument will
Search for stability, and automatically log the meas-
urement and beep when the stability criteria are met.
4
Unclamp the leaf. If Prompt on log is enabled, the data
labels screen will appear. Follow the instructions for data
labels in Step 2.
5
Add remark: after a measurement is taken, you can add
an optional remark to the measurement by pressing the right