LI-COR LI-710 - Swivel Mount; Mounting Kit with Riser Bar; Cross Bar and Mounting Hardware

To Next Page

To Previous Page

Section 1. Introduction to the LI-710

Swivel mount

Part number

259-13275

The LI-710 can mount to a vertical mast (1" outside diameter) with a ¾" swivel

mount.

Mounting kit with riser bar

Part number

7900-340

The mounting kit includes a crossover fitting (¾" × 1"), swivel mount (¾"), and a 56

cm (22") riser bar.

Figure 1-2. The crossover fitting, riser bar, and swivel mount are available individually or

as a kit.

Cross bar and mounting hardware

The following components can be used to add a cross bar to a mast with an outer

diameter of 2.375" (about 6 cm).

Cross Bar (1): 1.5 m long, 3.3 cm OD Schedule 80 aluminum pipe 6061-T6.

Part number

9879-010

Mounting Plate: For mounting the cross bar to a mast.

Part number

9879-020

Brackets (4): For mounting the cross bar to the mast.

Part number

9879-043

Mounting Hardware Kit: For mounting the cross bar to a mast.

Part number

9979-018

1-4 LI-710 Evapotranspiration Sensor Instruction Manual