LI-COR LI-710 - Section 2. Deploying the LI-710; Deployment Considerations

Section 2.
Deploying the LI-710
The LI-710 is designed for easy installation into meteorological stations. It uses a
single cable for power and communications (SDI-12 protocol). Remove the caps that
cover the transducers and air intake before powering on the LI-710 (see Figure 2-1
below).
Figure 2-1. Protective caps should be removed before powering on the sensor.
Deployment considerations
The LI-710 can be deployed as a stand-alone sensor, in a weather station, or as part
of an eddy covariance flux station. There are a few considerations that will help
ensure that the data you collect accomplishes your measurement goals.
2-1LI-710 Evapotranspiration Sensor Instruction Manual