Communicating with a command-line interface 4-3
Use transparent mode 4-3
Get the address 4-3
Device information 4-3
Set the address 4-4
Adding a variable set to a scheduled output 4-4
Turn off or on the scheduler 4-5
Report the measurement immediately 4-5
Logging data to your computer 4-6
Section 5. Connecting to Campbell Scientific dataloggers
Requirements for this tutorial 5-1
Configuring the datalogger 5-2
Retrieving logged data 5-5
The PC400 terminal program 5-6
Get the address 5-6
Set the address 5-6
Get information 5-7
Read current data from a group 5-7
Simple program with comments 5-7
Section 6. Connecting to the Sutron 9210 datalogger
Requirements for this tutorial 6-1
Configuring the datalogger 6-2
Retrieving logged data 6-5
More SDI-12 options 6-7
Find sensors 6-7
Get information 6-7
Set the address 6-8
Section 7. Data and variables
Group 0: Results 7-1
Group 1: Results and sample count 7-2
Group 2: Air, humidity, and instrument information 7-3
Group 3: Performance information and diagnostics 7-3
Section 8. Troubleshooting
Diagnostic codes 8-1
vi
To Next Page
Loading...