-39- v2.9
Data Access
After a correct upload you will see the date of the le saved. Then you can see this new raw data le in the Web
Server or in the Mobile APP.
At any time you can navigate back to return to the previous screen by clicking the arrow on the top left of the
screen.
NOTE: The Firmware of MySignals SW manages all the sensors at the same time and monitors the response of the screen and the
touchscreen. For this reason sometimes during the measurement of dierent sensor like blood pressure or other wireless sensors
it will be able to perform one action at the same time, you have to wait it to nish before being able to navigate or interact with
the screen again.
Figure: Detail mode Web Server
• Red color indicate that you can not use the touchscreen in this moment. So try to keep the zone pressed until
you receive a visual response on the TFT.
• Green color indicate that you can use the touchscreen as usual.
There is available too in the bottom of the screen a black zone where mysignals will write text indications about
the actual state of the device.
To Next Page
Loading...
