LINET Image 3 B Instructions For Use And Technical Description

D9U001AM2-0101_0630
9.5 Before Use
CAUTION!
Material damage due to temperature difference!
► If there is a considerable temperature difference between the bed and the place of operation
(after transport/storage), leave bed unconnected for 24 hours to allow the temperature to equalise.
Prepare the bed for service as follows:
► Dispose of all packaging (see Disposal).
► Connect the bed to the mains.
► Charge the accumulator.
► Raise the mattress platform to the highest position.
► Remove the isolating foil from control section.
► Lower and tilt the mattress platform to the lowest position.
► Check the castors and main brake work correctly.
► Check the bed extension works correctly.
► Check it is possible to remove the head and foot boards.
► Check all of the functions on the control elements (Attendant Control Panel etc.).
► Check the siderails function properly.
9.6 Transport
For safe transport, observe the following:
► Ensure no cables are run over when moving a bed.
► Ensure the mains cable is attached with a hook (at the head end of the bed).
► Ensure the castors are unlocked before moving the bed during the loading/unloading process
(see Castor Control and Bed Transport).
► Ensure the siderails are lifted and locked while the patient is on the bed during the transport.
► Move the bed only on suitable oor surfaces.
Suitable surfaces:
■ Tile
■ Hard linoleum
■ Hard ooring
Unsuitable surfaces:
■ Soft, unsealed or defective ooring
■ Soft wooden ooring
■ Soft and porous stone oors
■ Carpeted oors with underlay
■ Soft linoleum
□ For longer distances, ensure the castor steering function (main control) is activated.
□ Ensure the brakes are released while moving the bed.
9.7 Firmware
The bed includes rmware that can be updated only by an authorised service technician.
This rmware is protected against unauthorised access by mechanical housing (tool is needed to access), by seal (com-
ponents with processor are sealed), by exclusive compatibility with an authorised software tool and by check of compati-
bility of the new rmware with the bed.

LINET Image 3 B Specifications

General

Brand	LINET
Model	Image 3 B
Category	Medical Equipment
Language	English