D9U001AM2-0101_06
33
11.4 Deactivating the Accumulator
To avoid damaging the bed and the environment during storage:
► Deactivate the accumulator on the Attendant Control Panel.
To deactivate the accumulator on the Attendant Control Panel:
► Disconnect the bed from the mains.
► Disconnect the ground wire.
► Activate the keypad by pressing the GO button on the Attendant Control Panel.
► Press the Thighrest Up + Thighrest Down + Trendelenburg Position buttons at the same time and hold
them for three seconds.
► The accumulator is deactivated.
NOTE: Try some functions to ensure the accumulator is deactivated.
To activate the accumulator again:
► Connect Power Cable to the mains.
12 Manipulation
WARNING!
Risk of injury when adjusting the bed!
► Ensure there are no body parts between the mattress platform elements and the mattress platform frame when
adjusting the bed.
► Ensure there are no body parts below the mattress platform frame before adjusting the bed.
► Secure or remove any items on the bed.
The bed is operated by different control elements.
Control elements:
► ACP Attendant Control Panel
► Handset
Disabling individual functions on the Attendant Control Panel affects all of the control elements.
If the bed does not react to individual position settings:
► Check whether the function is disabled on the Attendant Control Panel.
To Next Page
Loading...
Need help?
General
