D9U001MC0-0101_16
33
To cancel this status:
► Press STOP button.
Status “Discharged accumulator”
The accumulator is regarded as discharged if the following condition is met:
■ Dened decrease of voltage depending on discharging current
■ This status is indicated by the accumulator status indicator ashing quickly.
■ The electric CPR position is the only possible position.
■ This status will be cancelled automatically when the bed switches to sleep mode.
To cancel this status:
► Press STOP button.
10.3 Removing the Bed from Use
Remove the bed from service as follows:
► Disconnect the bed from the mains.
► Disconnect the ground wire.
► Deactivate the accumulator.
► Remove accessories.
To prevent damage during storage:
► Pack or cover the bed and accessories.
► Ensure that storage conditions are the same as the operating conditions.
10.4 Deactivating the Accumulator
To avoid damaging the bed and the environment during storage:
► Deactivate the accumulator on the Attendant Control Panel.
To deactivate the accumulator on the supervisor:
► Disconnect the bed from the mains.
► Disconnect the ground wire.
► Activate the keypad by pressing the GO button on the supervisor.
► Press the Thighrest Up + Thighrest Down + Trendelenburg Position buttons at the same time and hold them for three
seconds.
The accumulator is deactivated.
To activate the accumulator again:
► Connect Power Cable to the mains.
To Next Page
Loading...
Need help?
General
