LINET Multicare User Manual

D9U001MC0-0101_16 69
18.7 Protector
WARNING!
Risk of injury due to the patient falling off the bed!
► Ensure that the Protector is installed securely.
► Always check that the siderails are properly locked.
The Protector is an optional accessory for the Multicare bed. The main purpose of the Protector is to reduce the risk of patients
falling off the bed.
Fig. Multicare bed with Protector
1. Inserting the Protector into the casing in the protective ring on the corner
2. The Protector inserted in the casing
3. The xing element attached to the telescopic prole of the bed extension
4. The Protector attached to the Multicare bed (The Protector can also be used on expanded beds.)
Attach the Protector to the bed as follows:
► Insert the Protector pin into the casing in the protective ring at the corner of the foot end of the bed (1).
► Ensure that the xing element is secured to the telescopic prole of the bed extension (3).
Remove the Protector from the bed as follows:
► Grasp the upper end of the Protector.
► Remove the Protector from the casing.

LINET Multicare Specifications

General

Height Adjustment	Yes
Manufacturer	LINET
Model	Multicare
Bed Type	Electric
Length Extension	Yes
CPR Function	Yes
Side Rails	Yes
External Width	102.5 cm (with side rails)
External Length	224 cm (standard)
Mattress Platform Width	900 mm
Mattress Platform Length	200 cm
Maximum Thighrest Angle	30°
Type	Hospital Bed
Application	Hospital, Clinic, Home Care