LINET Multicare

D9U001MC0-0101_16 63
17 Mattress
Multicare bed is designed for passive and active mattresses from LINET portfolio.
CAUTION!
Incompatibility with bed due to incorrect mattress dimensions!
► Check maximum approved mattress dimensions (chapter Technical Specication).
The manufacturer recommends the use of the following mattress systems on the Multicare bed:
PASSIVE MATTRESSES
■ CliniCare 10
■ CliniCare 20
■ CliniCare 30
ACTIVE MATTRESSES
■ Virtuoso (not integrated)
■ S y m b i o s o ( i n t e g r a t e d )
■ O p t i C a r e ( i n t e g r a t e d )
17.1 Passive Mattress
Recommended Passive Mattresses are equipped with straps (1) intended for xing mattress on the Mattress support platform.
Fig. Bottom of Passive Mattress
1
1
HEAD END
FOOT END
1
17.1.1 Straps with side release buckles
To x mattress on the Mattress Support Platform:
► Run three straps through the three corresponding holes in the covers of Mattress Support Platform.
► Run these three straps under the bars of the Mattress Support Platform.
► Lock the three side release buckles by connecting their male and female parts together.
To remove mattress from the Mattress Support Platform:
► Release the three buckles by pressing them from both sides and by disconnecting their male and female parts.
► Pull these three straps out of the Mattress Support Platform.
► Remove mattress from the Mattress Support Platform.