D9U001ES1-0101_0850
12.1 Anti-slip coating
CAUTION!
CAUTION!
-
The bottom surface of the Sprint 100 mattress has an ‘anti-slip’ coating. This is intended to help prevent the mattress moving
around on the Sprint 100 mattress support platform during patient transport, mattress support platform articulation or whilst the
patient is moving around.
12.2 Installation of Passive Mattress
The Sprint 100 passive mattresses are shaped to t the Mattress Support Platform during bed positioning.
Fig. Passive Mattress (Sprint 100 with 2-part mattress support platform)
Fig. Passive Mattress (Sprint 100 with 4-part mattress support platform)
12.2.1
The Sprint 100 passive mattresses can be equipped with straps with buckles to x mattress on the Mattress Support Platform.
► Run four straps through the four corresponding holders on the frame of Mattress Support Platform.
► Lock the four side release buckles by connecting their male and female parts together.
To remove mattress from the Mattress Support Platform:
► Release the four buckles by pressing them from both sides and by disconnecting their male and female parts.
► Pull four straps out of the four holders on the frame of Mattress Support Platform.
► Remove mattress from the Mattress Support Platform.
To Next Page
Loading...
Need help?
General
