Linksys SLM224G2

Chapter 5
Advanced Configuration
21
24-Port 10/100 + 2-Port 10/100/1000 Gigabit Advanced Smart Switch with 2 Combo SFPs
Security > Management Access List
Management Access List specifies which Source IP
addresses can manage the device.
Security > Management Access List
Mode Enable or Disable Management Access List.
Management Address 1 Enter the designated IP address
to allow accessing the device.
Management Address 2 Enter the designated IP address
to allow accessing the device.
Management Address 3 Enter the designated IP address
to allow accessing the device.
Management Address 4 Enter the designated IP address
to allow accessing the device.
Management Address 5 Enter the designated IP address
to allow accessing the device.
Management Address 6 Enter the designated IP address
to allow accessing the device.
Management Address 7 Enter the designated IP address
to allow accessing the device.
Management Address 8 Enter the designated IP address
to allow accessing the device.
Click Save Settings to save the changes.
Security > Storm Control
Security > Storm Control
Apply Settings to all ports Click the check box to apply
Storm Control settings to all ports.
Port Indicates the port number for which storm control
is enabled.
Storm Control Type Specifies the Storm Control Type
currently enabled on the device. The possible field values
are:
Disabled Disable Storm Control.
Broadcast Only Counts only Broadcast traffic.
Broadcast and Known Multicast Counts Broadcast
and known Multicast traffic.
NOTE: The MAC address of multicast traffic
must be learned by the Switch first; otherwise,
it will be treated as unknown unicast traffic.
Broadcast and Unknown Unicast Counts Broadcast
and Unknown Unicast traffic.
Broadcast, Multicast, and Unknown Unicast Counts
Broadcast, Multicast, and Unknown Unicast traffic.
Storm Control Rate Specifies the Storm Control Rate.
Click Save Settings to save the changes.
Security > Port Security
Network security can be increased by limiting access on
a specific port only to users with specific MAC addresses.
MAC addresses can be dynamically learned or statically
configured. Locked port security monitors both received
and learned packets that are received on specific ports.
Access to the locked port is limited to users with specific
MAC addresses. These addresses are either manually
defined on the port, or learned on that port up to the
point when it is locked. When a packet is received on a
locked port, and the packet source MAC address is not tied
to that port (either it was learned on a different port, or it
•
•
•
•
•