Linksys SLM224G2

Chapter 5
Advanced Configuration
36
24-Port 10/100 + 2-Port 10/100/1000 Gigabit Advanced Smart Switch with 2 Combo SFPs
Admin > Port Mirroring
You can mirror traffic from any source port to a target port
for real-time analysis. The Switch supports only one mirror
session.
Admin > Port Mirroring
Mode Enables or disables Port Mirroring
Port ID Displays the port number.
Ingress Mirror Click on check box to select ports to which
ingress traffic will be mirrored on those selected ports.
Egress Mirror Click on check box to select ports to which
egress traffic will be mirrored on those selected ports.
Mirror To The target port that will mirror the ingress and
egress traffic on the selected ports.
Click Save Settings to save the changes.
Admin > Cable Test
Admin > Cable Test
To test the connection quality for an attached cable, select
the port from the pull-down window and click Proceed.
NOTE: The cable needs to be connected at both
ends, otherwise the test will fail.
The cable test results for each port are displayed in the
table.
Admin > Save Configuration
The Save Configuration screen allows you to save and load
configuration information using your Web browser.
Admin > Save Configuration
Via HTTP
Upgrade Select this option to load a previously saved
configuration file (.cfg) from a file in a specified location.
To load the file, perform the following steps:
In the Source File field, type in the path and name of
the file or click Browse to locate the file.
Click the Proceed button.
Click the OK button.
Wait until the Continue button becomes available and
click Continue to complete the process.
Backup This option creates a configuration file (.cfg) that
contains all of the configuration settings of the Switch to a
specified location. To save the configuration file, perform
the following steps:
Click the Proceed button.
Click the Save button.
Select a location to save the file to and click Save.
Click the Close button.
Via TFTP
Upgrade Select this option to upgrade the Switch from a
file located on a TFTP server.
TFTP Server Enter the TFTP Server IP Address that
contains the source file to upgrade from.
Source File Specifies the name of the upgrade file on
the TFTP Server.
1.
2.
3.
4.
1.
2.
3.
4.
•
•