CHAPTER 8: OPERATION 8-13
ALPHA 552
Misc: Front rest setup
Use this function to adjust front rest open/closed
positions.
5.8. Service parameters
Service: Main screen
Main screen
SERVICE: Barfeeder setup
Defines the Bar feeder length, pusher length and
pusher type.
SERVICE: Barfeeder setup
Automatic halt push forward at EOB
If this parameter is set to YES, the bar feeder don’t
push forward at end of bar (Only with swiss type
lathe).
Hydraulic pump ON with front rest open
The hydraulic pump continue to supply oil to the
guiding channel.
Front rest closed on pusher
Only with fixed headstock lathe!
Close the front rest on the pusher during
machining.
Front rest opening is synchronized with lathe
clamping device opening.
This parameter reduces vibrations.
To Next Page
Loading...
