8-14 CHAPTER 8: OPERATION
ALPHA 552
SERVICE: Barfeeder setup
Feed out safety tolerance
Tolerance added to the entered part length value to
avoid an groundless alarm. (default:10mm)
Position behind the clamping device
Position of the collet behind the clamping device
SERVICE: Torque & feed rate
Without bar stock
Pusher feed rate without bar stock
With clamping device closed
Pusher torque with clamping device closed
SERVICE: Torque & feed rate 2
Default values insertion/exctraction: 100%
Default value Booster servo: 300%
SERVICE: Feed rate
Feed rate values.
To Next Page
Loading...
