67
6. DELAY
You can add a delay between commands. This is different to the delay you can see between key and mouse button
presses whilst making a command in a macro, but is configured the same way:
To add a delay, select DELAY from the from the drop down menu. The default value will be 50ms but this can be
changed. You can add a delay at the start or after any other macro options
1. Clicking DELAY has added the default 50ms to the end of the command
2. Clicking DELAY has inserted a delay of 50ms to the start of the command. Any command added after will
operate after that delay.
3. This is the delay between the down and uppress of the 1 key and is generated through RECORD KEYSTROKES .
You can change that timer by clicking on MACRO OPTIONS and unchecking USE STANDARD DELAYS.
To Next Page
Loading...