www.longer3d.com support@longer.net
2) Connect Nano to LightBurn by WIFI in STA mode
Run the LightBurn, connect PC to Nano, right click ‘Connect to WIFI’
in console window to set WiFi information, change Your_SSID and
Your_PassWord to your WIFI account and password in $sta/ssid and
$sta/password command, click OK, left click ‘Connect to WIFI’ to
change it to STA mode. After the connection is successful, the
console prompts the ‘status = connected’ and the IP address. Please
note that the computer network and WIFI must be in the same LAN
(local area network). Click Devices in Laser window, select Laser
Nano > Edit > GRBL > Next > Ethernet/TCP > Next > input IP
address > Next > Next > Next > Finish > OK, click Device Settings >
input 8847 in Network Port > OK.
To Next Page
Loading...
