LONGER Nano - Connect Nano to Lasergrbl by WIFI

www.longer3d.com support@longer.net
22
⑥Grbl reset/homing/unlock: this buttons submit soft-reset, homing
and unlock command to grbl board. On the right of unlock button
you can add some user defined buttons.
⑦ Pause and resume: this buttons can suspend and resume
program progress.
5. Connect Nano to LaserGRBL by WIFI
There are two modes: STA or AP to connect Nano to the LaserGRBL
via wifi. The difference is that in AP mode, the computer has no
network, while in STA mode, computer can maintain network.
1) Connect Nano to LaserGRBL by WIFI in AP mode
Run the LaserGRBL, click Grbl > Settings, select Telnet in the
Connection Protocol and Save, click ‘WiFi reset’ in the bottom
of the window to set WiFi to AP mode, connect the computer to the
WiFi that starts with LongerLaser_Nano, input password 12345678,
input 192.168.0.1:8847 in IP:PORT, click to connect.