8
www.longer3d.com info@longer3d.com
Do not pull out the TF card during printing, it will cause
printing failure.
Elapsed time from start printing.
Remaining time to printing completion.
Printing process of current layer and total layers.
Real-time temperature of LED PCB.
Real-time status, such as printing, pausing, paused.
Pause the printing job. The status will change to pausing
when start to pause, and change to paused after the
current layer is printed over. The progress will be paused
after exposure and the end of the Z axis movement
when paused during exposure. While it will be paused
after the end of the Z axis movement, exposure, and
finish of Z axis motion once again when paused during Z
axis motion.
Resume the paused printing job, and it is disabled
during pausing status.
Cancel the printing job. The progress will be stopped at
once when cancelled during exposure, while it will be
stopped after the end of the movement when cancelled
during Z axis motion. The Z axis moves up about 40mm,
and it will be back to main menu after cancelled.
To Next Page
Loading...
