102
DRIVER ASSISTANCE
Adjusting Maximum Speed
With speed limiter active:
Press either the
or ‘-
’ buttons to increase or
decrease the maximum speed.
Briefly press and release the or
‘-’ buttons to increase or decrease the
maximum speed by 5 mph. Longer
presses will increase or decrease the
maximum speed in 1 mph increments.
Deactivation
Press the
button. The
symbol and set speed will
illuminate white in the driver’s
display. The speed limiter is
now in standby mode.
Resuming
With speed limiter deactivated (but not
turned off):
Press the
button to
reactivate. The speed limiter
set speed and symbol in the
driver display will change color
from white to green.
The vehicle will now only accelerate up
to the preset stored speed.
To Turn Off
From Standby Mode:
Press
or button to display
another option.
When Active:
– Press the
button to set speed
limiter to standby mode.
– Then press
or on the left-
hand steering wheel keypad to
display another option.
The
symbol will extinguish and the
maximum set speed is deleted.
Speed limiter will remain active if
changing between driving modes but
cancels whenever the engine is turned
off.
Temporary Deactivation of Speed
Limiter
During overtaking, the vehicle speed
might have to be higher than the set
speed limit. To temporarily deactivate:
– Fully press the accelerator pedal
until the speed limiter is temporarily
deactivated.
– You can then overtake the other
vehicle.
– Fully release the accelerator pedal
when the temporary acceleration is
finished.
Engine braking will then automatically
restore the vehicle speed to below the
last stored maximum speed.
To Next Page
Loading...
