242
10. Ensure the
on-off button on the
compressor is set to off.
11. Position the compressor near the
tire, ensuring the sealant bottle is
upright.
12. Remove the valve cap from
punctured tire.
13. Screw the transparent airline hose
to the tire valve.
14. Connect the compressor connector
to the 12V auxiliary power socket,
see page 166.
NOTE: It is recommended to run
the engine to avoid discharging the
battery.
VEHICLE CARE
15. Press the on-off button to start
the compressor.
Correct Tire Pressure Not Achieved
See page 243.
Correct Tire Pressure Achieved
If the tire has reached the correct pres-
sure:
16. Switch off the compressor using
the
on-off button, disconnect
the sealant tube from the tire valve,
remove the speed sticker from the
side of the sealant canister and put
in the vehicle cabin where it can be
easily seen.
17. Disconnect the compressor con-
nector from the 12V auxiliary power
socket, press the button on the side
of the compressor to detach the
tire sealant bottle and refit the tire
valve cap.
18. Refit the compressor and tire seal-
ant bottle into the kit box and refit
securely back into place within the
luggage compartment.
19. You can continue driving, but do not
exceed 50 mph. Do not accelerate
or brake suddenly.
20. After driving for about 5 miles,
stop the vehicle in a safe place and
engage the handbrake.
To Next Page
Loading...
