57
Removing the Battery
Lifting the battery up from its edge,
remove it from the keyfob.
Installing a New Battery
Ensure the battery is facing with the
(+) side upwards. With the edge of the
battery slightly downwards, place the
battery into the battery holder.
CAUTION: Avoid touching the
electrical contact surfaces on new
batteries with your fingers as this
may impair its function or reduce is
usable life.
NOTE: Replace only with a 3V,
CR2032 type battery.
Closing the Battery Case
Slide the hooked lipped end of the
battery cover into the slots at the
end of the keyfob case, then close
the battery cover back into place, a
clicking noise indicates that the cover
is securely closed.
WARNING: Check that the battery
is fitted correctly. If the keyfob will
not be used for a long time period,
remove the battery to avoid
battery leakage and damage.
Damage or leaking batteries
may cause corrosive injury on
contact with the skin. Always use
protective gloves when handling
damaged batteries.
WARNING: Keep batteries out of
the reach of children and pets as
they can be swallowed.
WARNING: Batteries must not
be dismantled, short-circuited or
thrown into open flames.
WARNING: Do not attempt
to charge non-rechargeable
batteries, this may cause an
explosion.
KEYS, LOCKS & ALARM
To Next Page
Loading...
