1. General information
Please read through this document carefully and familiarise yourself with the operation of
the device before you use it. Keep this document to hand and in the immediate vicinity of
the device so that you or skilled personnel can refer to it at all times.
Assembly, set-up, operation, maintenance and decommissioning may only be performed
by specifically qualified personnel. The skilled personnel must have carefully read and
understood the operating manual prior to commencing with any type of work.
The liability and warranty of the manufacturer for damages and consequential damages are
void in the event of improper use, non-observance of this operating manual, assignment of
insufficiently qualified skilled personnel and arbitrary modification of the device.
The manufacturer is not liable for costs or damages arising to the user or third parties from
the use of this device, in particular as a result of improper use of the device or misuse or
faults of the connection or the device.
The manufacturer assumes no liability for printing errors.
2. Safety
2.1 Intended use
The device is designed for the measurement of conductivity, specific resistance, salt content
and TDS with the use of suitable electrodes (measurement cells). The electrode connection is
made via a 7-pin bayonet connection.
Please observe: Different electrode types may be required depending on the measurement range -
ensure that you have made the appropriate selection
It is likewise possible to connect a temperature sensor (Pt1000 or NTC 10k) by means of the
7-pin bayonet connection. Normally a suitable temperature sensor is already integrated in the
electrode. The measured temperature is used by the automatic temperature compensation
(e.g. Lin or nIF) for the measurement and is also displayed.
The safety instructions in this operating manual must be observed (see below).
The device may only be used under the conditions and for the purposes for which it was
designed.
The device must be handled with care and used in accordance with the technical data (do
not drop etc.). Protect from dirt.
2.2 Safety signs and symbols
Warning notices are identified in this document as follows:
1. Warning! This symbol warns of an immediately threatening danger;
fatality, severe injury and/or extensive property damage may be the
result of non-observance.
2. Attention! This symbol warns of potential dangers or hazardous
situations which may cause damage to the device and/or the envi-
ronment as a result of non-observance.
3. Note! This symbol draws your attention to processes which have an
indirect influence on the operation or may trigger an unforeseen
reaction as a result of non-observance.
i
!
To Next Page
Loading...
Need help?
General
