7. Device configuration
Some menu items are only accessible depending on the current device setting (e.g.
some are locked when they contain logger data).
Press and hold "menu" for two seconds for the configuration, where the menu
("SEt" main menu) is opened.
Select the desired menu branch with „menu“.
Jump to the corresponding parameters which you can then change.
Selection of parameters
Press again to switch back to the main menu and save the settings.
Close the configuration.
If the buttons "menu" and "store" are simultaneously pressed and held for longer
than two seconds, the device is reset to the factory settings. If data in the
single value logger (Logger: "Func Stor) is first shown as "rEAd Logg" menu:
see also Chapter 8 Data logger for this purpose. If no button is pressed for
a period of more than two minutes, the configuration is cancelled. No changes made
up to that point are saved!
To Next Page
Loading...
Need help?
General
