Lovol TE Series - Maintenance of Tractor During Sealing Period; Unsealing of Tractor

Storage
6.3 Maintenance of the Tractor during Storage
6.3.1 Tractors must meet the above requirements of tractor storage during storage.
6.3.2 Check the tractor and its parts for rusting, corrosion, aging, deformation and other abnormal
phenomena every month, and eliminate any problems found in time.
6.3.3 Every 2 months, rotate the engine crankshaft (10 ~ 15 turns) to prevent internal rusting. Remove the
old grease and replace it with a new one at the lubrication part to be filled with grease.
6.3.4 Every 3 months, the tractor should be started and driven at a low speed (20 ~ 30 min), and all parts
should be checked for any abnormal phenomena.
6.3.5 Wipe the dust on the top surface of the battery regularly with a dry cloth, and check the liquid level
and density of the battery electrolyte regularly according to the requirements of the Battery Instructions. The
battery discharges itself even if it is not used, thus the battery shall be recharged once a month.
Important: If the user does not have the conditions for anti-rust treatment and the tractor needs to be
idle for several months or longer, engine oil and oil filter shall be replaced at least, and the tractor
shall be started once a month, and it shall be driven at a low speed (20 ~ 30) min to check whether
there is any abnormal phenomenon in each part. Keep the exterior of the tractor clean and dry to prevent
corrosion of the tractor.
6.4 Unsealing of Tractor
6.4.1 Remove grease used for rust prevention.
6.4.2 Open all closed pipe orifices. Clean the tractor.
6.4.3 Add coolant, engine oil and diesel oil as required, and add grease to all lubricating points.
6.4.4 Check the voltage and install the battery in accordance with the Battery Instructions.
6.4.5 Remove the rust inhibitor from the groove of the fan belt and install the belt. Adjust the tightness of
the drive belt according to the technical requirements (see Engine Operation and Maintenance Instructions).
6.4.6 Install the battery, and coat the wiring terminals with vaseline.
6.4.7 Check the fastening situation of each circuit and pipeline.
6.4.8 Operate the tractor according to the instructions
Note: For sealing and unsealing of the engine, refer to Engine Operation and Maintenance
Instructions.
90