6.2 Storage of the Tractor
6.2.1 Before storage, carefully check the tractor, eliminate the existing faults and keep it in good condition.
Clean the appearance of the tractor.
6.2.2 Drain the antifreeze and anti-rust fluid in the radiator, cylinder block and water pump, lubricating
oil in the drive system and hydraulic oil in the hydraulic system.
6.2.3 Remove the battery, coat the pole with grease, and store it in a room which is lightproof, ventilated
and at a temperature over 10℃ (Celsius).
6.2.4 Drain the engine oil in the engine while it is hot, fill it with new engine oil, and let the small throttle
of the engine run for several minutes to make the oil evenly attached to the surface of each moving part.
6.2.5 Inject grease into each lubricating point
6.2.6 Apply electrical contacts, joints and surfaces of unpainted metal parts with dehydrated vaseline
[heated to (100~200) ° C (Celsius)].
6.2.7 Loosen the engine fan belt, take it off if necessary, wrap it up and store it separately, and spray rust
inhibitor inside the pulley groove. The parts where the tractor surface is depainted shall be repainted.
6.2.8 Drain the diesel in the diesel tank and clean it.
6.2.9 Use protective materials (such as canvas, waterproof cloth or oil paper) to seal the open pipe orifices of
the engine, such as the inlet and outlet, to prevent foreign objects, dust and moisture from entering.
6.2.10 Place all the control handles in neutral position (including electrical system switch), put the front
wheels of the tractor in right position, and put the suspension rod piece in the lowest position.
6.2.11 Support the tractor with a wooden frame to release the load on tires. And regularly check the tire
pressure.
6.2.12 The tractor shall be parked in the warehouse or carport with a ventilated and dry environment. It is
strictly prohibited to store with corrosive objects and gases. If the conditions are not met, when parking in the
open area, the dry platform with a higher terrain must be selected and covered with rain-proof cloth.
6.2.13 Parts and on-board tools removed from the tractors shall be cleaned, wrapped and stored in a dry
warehouse.
To Next Page
Loading...
